Change "Soft Start Ramp up Rate" - Githubissues

lumapu / ahoy

Various tools, examples, and documentation for communicating with Hoymiles microinverters

https://ahoydtu.de

Other

948 stars 222 forks source link

Change "Soft Start Ramp up Rate" #1727

Open gerd289 opened 3 weeks ago

gerd289 commented 3 weeks ago

I wonder if it is possible to change the "ramp up rates" at the inverters? This could maybe solve the issue that inverters take a long time to increase the power level.

Hardware

[ ] ESP8266
[ ] ESP32
[ ] Raspberry Pi

Modelname: __ Retailer URL: __

nRF24L01+ Module

[ ] nRF24L01+ you verified this is a Plus model capable of the required 256kBit/s mode
[ ] square dot indicates original Nordic Semicon chip
[ ] round dot indicates copy-cat / counterfeit SI labs chip

Antenna:

[ ] circuit board
[ ] external antenna (SMA)

Power Stabilization:

[ ] 100uF Electrolytic Capacitor connected between +3.3V and GND (Pin 1 & 2) of the NRF Module
[ ] Voltage stabilizing motherboard

Version / Git SHA:

Version: ..__ Github Hash: ___

Build & Flash Method:

[ ] AhoyDTU Webinstaller
[ ] VSCode - Platform IO
[ ] Arduino
[ ] ESP Tools

Debugging:

[ ] USB Serial Log (attached)
[ ] Setup settings (use our templates ... to be added)

lumapu commented 3 weeks ago

This is a feature request to update the grid profile, this will may be included in future but not planed yet. This can currently only be done using the original DTU from Hoymiles.

See also #1199