Standalone version problem

legacy60000 commented 10 months ago

ATTENTION !

Use this form to report bugs in an Official Release of SoftRF firmware, hardware and web pages only ;
Issue reports from anonymous users will be most likely invalidated. Reasons for that are well explained here ;
Prior to asking a question, look into "Closed issues" area to see if it was answered before ;
No any "ideas" or new feature requests, please ! New feature requests do not subject for taking into consideration unless they come from co-developers ;
"Enhancements" of existing features are only allowed when you are ready to implement them by yourself. See CONTRIBUTING list for details ;

Recommended:

screenshot or photo width - from 600 to 800 pixels ;
aspect ratio - 4:3, 3:4, 16:9 or 9:16.
substitute 'space' by 'x' character to mark a hardware checkbox

Hardware

[x] Standalone
[ ] Badge
[ ] Prime Mark III
[ ] Prime Mark II
[ ] Dongle
[ ] SkyView EZ
[ ] SkyView Pico
[ ] Uni
[ ] Ham
[ ] Midi
[ ] Mini
[ ] Academy
[ ] Lego
[ ] ES Edition
[ ] Balkan
[ ] Raspberry Edition
[ ] UAV
[ ] WebTop Serial
[ ] WebTop USB
[ ] UAT978 module
[ ] Flight Recorder

< photo of your hardware > (required) 20240126_113944 20240126_113952 Screenshot_2024-01-26_120647 Screenshot_2024-01-26_121242

Firmware version

< screenshot of WebUI and/or SoftRF Tool status page > (required)

Firmware settings

< screenshot of WebUI and/or SoftRF Tool settings page > (required)

Describe the bug

After startup (changing colors etc..) the LED ring stays in kinda white dimmed state and buzzer stays continuesly on. After gps lock it goes to boot loop. No effect by removing the LED ring and led bar or anyway varying with HW pieces.

Checks done:

Erased NODEMCU before flashing FW
Used several different HW pieces
Power checked twice 3,30V
Flashed different versions of FW V1.0,V1.1...1.4

To Reproduce

Expected behavior

legacy60000 commented 10 months ago

Additional tryouts:

Removed the node mcu from shield:

Suplied 5v for LED ring - nil change Tryed different manufacturer of LED ring - nil change Went through all versions of FW - nil change Changed to different version of the ESP8266 board - nil change

Ok After deeper search I found this "Yes, this is intentional backlit for dark daytime or shade when it is hard to see the arrow on faceplate and determine relative position of an active ("traffic") LED." - this issue closed

but still remaining issue is the bootloop and continous buzzer - Can be this problem with gps baud rate?

lyusupov commented 9 months ago

Works fine to me.

Resolution: unable to reproduce

lyusupov / SoftRF