Open firex726 opened 1 year ago
EasyLoad is mostly only applicable to M5Core series products, and does not match Core2, it is possible that the AXP192 or the serial chip is burned out.
OK so where does it say that on your site? https://docs.m5stack.com/en/unit/thermal
I would think if this has the possibility of bricking a device then there should be a note or even some form of verification in the software to verify what is connected.
Hello @firex726
Good luck!
Thanks Felix
Describe the bug
M5 Core 2 module was working normally out of the box using the default firmware. I tried the example arduino code found here but it would not compile, after installing the needed boards and libraries.
I then tried the "EasyLoader" for the thermal camera found on your product page "https://docs.m5stack.com/en/unit/thermal". It appeared to burn the image and reported success, but now the module is bricked. And I cannot connect to it from the ArduinoIDE nor the M5Burner utility.
To reproduce
ArduinoIDE 1.8.16 & EasyLoder & m5Burner
Expected behavior
Arduino project should compile and load. EasyLoader should burn example to device.
Screenshots
No response
Environment
Additional context
No response
Issue checklist