search

mUVe3D / Marlin-mUVe1DLP-Running

Tested and Working DLP Printer Firmware w/Shutter Support
30 stars 12 forks source link

M42 command not working #6

Open haipham3d opened 6 years ago

haipham3d commented 6 years ago

I had try command M42 with servos and aux pin but this not working

mUVe3D commented 6 years ago

Can you please add more detail. We have tested servos working on several outputs. One output is reserved for laser firing from the laser firmware. We need to know more detail about your setup, the commands you are sending, and the expected output, before we can provide more details as to a solution. Thank you. mUVe 3D Support

haipham3d commented 6 years ago

I try M42 P4 S255 but nothing when check with voltage meter. Servos is still work fine with M280. I want to use D4 pin to control relay. When i enable Controller Fan, this pin also work but cant control with M42

mUVe3D commented 6 years ago

With servos enabled you will not be able to use M42 to control the servo pins. They become PWM pins and cannot be sent a simple high or low anymore. If you wish to do this process you will need to disable servos, or choose a different available pin.

haipham3d commented 6 years ago

I had just define number of servos less but it also not working. Same when tty with other pin