mainsail-crew / MainsailOS

This Raspberry Pi distribution for managing Klipper 3D printers with Mainsail provides all you need.

https://docs.mainsail.xyz/setup/mainsail-os

GNU General Public License v3.0

524 stars 250 forks source link

Add ability to use Pi 5 #295

Open ankonaskiff17 opened 2 months ago

ankonaskiff17 commented 2 months ago

Sorry about bold. i have tried to correct to no success **Please add Pi 5 as appropriate for last line. Not sure if lacking Pi 5 would cause installation to fail or not but currently only options Pi 3 & 4

JSON sniplet Setup

NOTE: Please see all config files for setup variables!!!

shellcheck disable=SC2034

JSON_SUPPORTED_SBC="pi3-64bit pi4-64bit"

meteyou commented 2 months ago

raspberry pi5 needs bookworm. right now, mainsail only use debian bullseye. so when we add pi5, it will not boot on a pi5.

keefo commented 1 month ago

Backup on this request.

This doc says the debian bookworm is ready for pi5. https://qengineering.eu/bookworm.html

meteyou commented 1 month ago

@keefo sry... I miswritten the post before. MainsailOS use bullseye.