If I click the SCREWS TILT CALCULATE dropdown, then hit CCW to make sure i am only tightening screws down, not loosening them, then hit "retry" on the shown modal, it runs SCREWS_TILT_CALCULATE
What did you expect to happen instead?
I expected it to run SCREWS_TILT_CALCULATE DIRECTION=CCW
How to reproduce this bug?
Enable screws_tilt_adjust in your printer.cfg
Click the 3 dots on the toolhead menu
Click the dropdown arrow next to SCREWS TILT CALCULATE
Click "CCW" or "CW" (either one works)
Click "retry", note that the executed command on the retry button is not the same as the command that initially triggered the modal
Mainsail Version:
2.11.2
Browser:
Firefox
Device:
Desktop PC
Operating System:
Windows
What happened?
If I click the SCREWS TILT CALCULATE dropdown, then hit CCW to make sure i am only tightening screws down, not loosening them, then hit "retry" on the shown modal, it runs
SCREWS_TILT_CALCULATE
What did you expect to happen instead?
I expected it to run
SCREWS_TILT_CALCULATE DIRECTION=CCW
How to reproduce this bug?
Additional information:
No response