"Disable CURRENT" in CLI does not disable

[GoogleCodeExporter]

Arducoper NG or ACM?
What steps will reproduce the problem?
1. No current sensor attached or enabled in Config
2. Click terminal tab
3. type 'logs', then 'enable all'.
4. type disable current

What is the expected output? What do you see instead?
Expect CURRENT to no longer appear in the list of enabled logs.
CURRENT shows as still enabled

What version of the product are you using? On what operating system?
ACv2.8.1 MP 1.2.18

Please provide any additional information below.
See attached the screen print here: 
https://picasaweb.google.com/lh/photo/9I1X8CR2_Vyp4A3IatCbcCvpImV_kRcnSE2hj9F3Pw
0?feat=directlink

Original issue reported on code.google.com by graham.d...@gmail.com on 8 Nov 2012 at 4:51

[GoogleCodeExporter]

Correct this is an error. 
To disable current in log you have to run the command "disable cur"

/Benny

Original comment by Benny.Si...@gmail.com on 23 Nov 2012 at 6:30

[GoogleCodeExporter]

[deleted comment]

[GoogleCodeExporter]

Issue moved to https://github.com/diydrones/ardupilot/issues/22

Original comment by Benny.Si...@gmail.com on 16 Jan 2013 at 5:59

[GoogleCodeExporter]

Issue moved to https://github.com/diydrones/ardupilot/issues/22

Original comment by Benny.Si...@gmail.com on 16 Jan 2013 at 6:50

• Changed state: Done