MKS Lite 1.1 can't work

[wudixiaobinbin]

Mother board is MKS Lite V1.1, step motor can't work, only shaking.

[mks-viva]

I test it ok: https://github.com/makerbase-mks/Klipper-for-MKS-Boards/tree/main/MKS%20Robin%20Lite%20V1.1 May be you need check your config or motor...

[wudixiaobinbin]

I test not ok. I can't find the python file, I want to make a bin file myself, may be the klipper version is different from us

[wudixiaobinbin]

motor is normaly worked with https://github.com/makerbase-mks/MKS-Robin/tree/master/MKS%20Robin%20Lite

[mks-viva]

So, you can use it. I will close this issues.

[wudixiaobinbin]

hey, my issue is klipper can't work on my MKS lite 1.1

[mks-viva]

?

[wudixiaobinbin]

you tell me to check my motor, I just tell you my motor is worked well, but can't work with klipper

[mks-viva]

You download my link firmware test?

[wudixiaobinbin]

Yes I used that firmware, And motor only shaking in place, can't move

[mks-viva]

Lite V1.1 uses pins to control the reference voltage, but I don’t see the Vref setting in the klipper firmware. You can remove the motor load and test it, if it is will move, so, maybe the current is too small.

[mks-viva]

https://github.com/makerbase-mks/Klipper-for-MKS-Boards/issues/4

[wudixiaobinbin]

Aha, Maybe that's the point, Z motor only can go down with heat bed

[mks-viva]

Yes, but I have not seen klipper's vref settings, so I suggest you not use klipper directly

[wudixiaobinbin]

Ok, thank you, maybe waiting for klipper update