search

makerbase-mks / MKS-DLC

MKS DLC support grbl firmware, can use Laser mode and CNC mode,support connect MKS TFT24/32/35 and TFT_CNC firmware support lasering and cnc operation...
https://www.aliexpress.com/item/32924263672.html?spm=2114.12010612.8148356.1.67302c46xDuwHo
95 stars 26 forks source link

Z probe #23

Open SlavaKot opened 2 years ago

SlavaKot commented 2 years ago

Hello everyone. which pin is responsible for the Z probe on the MKS-DLC board. I didn't find pin A5

raindancer2204 commented 2 years ago

Hello everyone, my question goes in the same direction. I have a Makerbase MKS DLC 2.1 with your CNC OS MKS_TFT24_CNC_V1.0.3.2 . I would now like to take advantage of the Z Probe.

It says sample at the bottom right, I've marked it in red. Where do I have to connect the 2 cables from the probe? It says V G S what goes where? I thank you in advance. Here is a picture of the mainboard.

I also looked here and the A5 pin would then look like this. But where do I have to attach the 2 cables?

cncmainboardskitze

regards

cncmainboard

cgmllr100 commented 2 years ago

Ground and signal if it is a two wire probe. If probe has lights and requires power, then you would need V.

Chopper266 commented 2 years ago

Yest thats correct, you just only need 2pin only A5(signal) and Grd..

Other hand iam already applyed this wiring but. When I execd my probe when this knive touch i got alarm hard limit, and this condition make me very confused.. until now iam try to figure out this problem.. I hope any body can give me advice i should to do? Thank you