search

makerbase-mks / MKS-DLC

MKS DLC support grbl firmware, can use Laser mode and CNC mode,support connect MKS TFT24/32/35 and TFT_CNC firmware support lasering and cnc operation...
https://www.aliexpress.com/item/32924263672.html?spm=2114.12010612.8148356.1.67302c46xDuwHo
94 stars 26 forks source link

Problem with DLC V2.1 board and TFT32 #25

Open cgmllr100 opened 2 years ago

cgmllr100 commented 2 years ago

I flashed the TFT32 with the "laser" option. I connected it to my DLC V 2.1 board as per the instructions. My stepper motors do not move and the laser will not fire. The manual for the DLC boards are really lacking in detail as well. Where is all the information regarding jumper settings for various motor driver's microstep settings. The Baud rate for both the board and the TFT32_L V4.0 are both set to 115200.

It will not work just using the board and a computer Gcode sender either. I have never had an issue like this with any other board I have used. The MKS-DLC 32 Bit board worked as soon as I set it up.

lethxl commented 2 years ago

Same problem… I flashed the cnc firmware on the tft 35, and grbl on the dlc 2.1… when everything is plugged in, I can’t move the steppers, and the top screen says disconnected… ??