Open Buzzydude opened 1 year ago
Looks to be the firmware is messed up or the ESP32 is broken. If you have an firmware image you can try to flash it again or use the MKS firmware as long it is using an MKS DLC32 board. You need to use the proper version for your board (V1.0 or V2.x).
I Already tried flashing the firmware, No change. I contacted the reseller, they are sending me a new motherboard.
I have a Acmer P1 engraver, which is always starting in Download mode, not Boot mode. In Lightburn console I get this: rst:0x10 (RTCWDT_RTC_RESET),boot:0x5 (DOWNLOAD_BOOT(UART0/UART1/SDIO_FEI_REO_V2)) .How can I solve this?