search

makerbase-mks / MKS-EAGLE

MKS Eagle is an integrated design version of Nano V3.0. It retains the functions of Nano V3, but intergrates 5 TMC2209 drivers on board with UART mode, and uses integrated heat dissipation and four-layer PCB optimization design.
https://www.aliexpress.com/item/1005003183498253.html?spm=a2g0o.store_pc_home.productList_8356958.pic_0
GNU General Public License v3.0
13 stars 2 forks source link

install firmware #6

Open MATTAM1981 opened 2 years ago

MATTAM1981 commented 2 years ago

Hi, I have some problems installing the firmware, if I insert the sd card with the .bin file nothing happens, I have tried various formatting of the sd card but the result does not change. The screen, mks h43, stays on the home page and nothing happens, I have already updated the screen and it works, do you have any suggestions?

Voxel3DPrinting commented 2 years ago

Hi, I experienced the same issues. You need to put the firmware file called "mks_eagle.bin" on the SD card. Not the normal "firmware.bin" as with other mainboards

MATTAM1981 commented 2 years ago

Yes I know, I have read the guide and followed but the card shows no signs, I also tried to follow the guide for the nano v3, but that doesn't work either