SWITCHING_EXTRUDER pin - Githubissues

makerbase-mks / MKS-Robin-E3-E3D

MKS Robin E3 E3D 32Bit Control Board 3D Printer parts with tmc2209 Uart mode driver For Creality Ender 3 CR-10

https://www.aliexpress.com/item/4000781744682.html

GNU General Public License v3.0

118 stars 97 forks source link

SWITCHING_EXTRUDER pin #158

Open countcobolt opened 2 years ago

countcobolt commented 2 years ago

Hi all

which connection pins should I use for using a switching extruder?

Kind regards

Steve

MKS-hosiey commented 2 years ago

Toggle extrusion? This motherboard only supports single extrusion

countcobolt commented 2 years ago

A toggling extrusion does not need a second connector, but uses a small servo to toggle which filament is being fed. You only need 1 extruder (which we have connections for) and through some printed parts, it selects which material is feeding as the servo will push either one or the other part. This is part of the stock marlin firmware. The question is, is there a connector I can use to connect a small servo to?

Kind regards