search

makerbase-mks / MKS-Robin-E3-E3D

MKS Robin E3 E3D 32Bit Control Board 3D Printer parts with tmc2209 Uart mode driver For Creality Ender 3 CR-10
https://www.aliexpress.com/item/4000781744682.html
GNU General Public License v3.0
118 stars 97 forks source link

How to upload bootloader ? #62

Closed Seelenkind closed 3 years ago

Seelenkind commented 3 years ago

Hi, how to upload bootloader ? i want to slience the beep at start

https://github.com/makerbase-mks/MKS-Robin-E3-E3D/tree/ender3-3d-touch/firmware/Bootloader

i connected PC with MKS Board with FTD232 USB to Serial Modul. but Flash Loader Demonstrator can not find Board , but connected as Com Port 8

thx

mks-viva commented 3 years ago

Hi! https://github.com/makerbase-mks/MKS-Robin-E3-E3D/issues/43

Seelenkind commented 3 years ago

Hi! #43 Hi, I already found this question in the archive and am not sure which of these pins should be pin 60? Pin 60 (boot modus) should either be on 3.3. set or the connection to GND disconnected. But which one is it exactly? Why isn't a jumper installed on the board to put the board in bootloader upload mode? image

mks-viva commented 3 years ago

Hi! About 60pin map image This may be something we did not consider, I am sorry. But MKS Robin E3/E3D has TF update firmware function

mks-viva commented 3 years ago

Hi! If there is no response, then I will temporarily close this question.