makerbase-mks / MKS-Robin-Nano-V1.X

MKS Robin Nano is a powerful 32-bit 3D printer control board with STM32F103VET6. Support Marlin2.0. Support MKS Robin TFT24/28/32/35/43 touch Screens. The motherboard integrates 5 AXIS interface, hot bed, 2 heating heads, 3 NTC100K, 1 MAX31855.The motherboard integrates After shutdown. Support MKS Robin WIFI for cloud printing and supports firmware update by SD card…
https://www.aliexpress.com/item/33013776323.html?spm=2114.12010612.8148356.5.320565f4m9CS1x
199 stars 75 forks source link

24v powered board thermal swing #102

Open meteozond opened 3 years ago

meteozond commented 3 years ago

There is some information about noisy 5v line if the board is powered via 24v adapter.

I've ran into this problem too on my v1.2.

Temperature sensor is fluctuating up to 4-5 Celsius even with powered off heaters.

image

Powering over 5v usb or 12v power adapter eliminates this.

So what is the best way to fix it without replacing capacitors or power adapter to 12v?

mks-viva commented 3 years ago

Hi! You only connected temperature sensor on the board?

meteozond commented 3 years ago

Hi! You only connected temperature sensor on the board?

Yes, after facing this problem I've removed all connected devices. Problem hasn't gone :( Connecting through usb only gives better picture:

image

I've tested two new power adapters 24v and 12v - both shows same picture:

24v image

12v image

meteozond commented 3 years ago

Just received and tested several replacement cards:

Looks like all Robin series boards give unstable temperature reporting what leads inconsistent prints 😡