search

makerbase-mks / MKS-Robin-Nano-V1.X

MKS Robin Nano is a powerful 32-bit 3D printer control board with STM32F103VET6. Support Marlin2.0. Support MKS Robin TFT24/28/32/35/43 touch Screens. The motherboard integrates 5 AXIS interface, hot bed, 2 heating heads, 3 NTC100K, 1 MAX31855.The motherboard integrates After shutdown. Support MKS Robin WIFI for cloud printing and supports firmware update by SD card…
https://www.aliexpress.com/item/33013776323.html?spm=2114.12010612.8148356.5.320565f4m9CS1x
197 stars 75 forks source link

Configuring LINEAR ADVANCE #23

Open ttutuncu opened 4 years ago

ttutuncu commented 4 years ago

Hi, How can we configure linear advance in MKS Robin Nano? LIN_ADVANCE

makerbase-mks commented 4 years ago

Hi! Are you use marlin2.0 or Nano's firmware? If it is marlin2.0, then you can directly set it in configuration_adv.h, if it is the motherboard's own firmware, it may not be supported yet.

ttutuncu commented 4 years ago

I am using Nano's firmware. I don't want to loose the fancy UI of the firmware because I use a touchscreen.

Sergey-Afonin commented 4 years ago

Hi! Are you use marlin2.0 or Nano's firmware? If it is marlin2.0, then you can directly set it in configuration_adv.h, if it is the motherboard's own firmware, it may not be supported yet.

Unfortunately changing thi setting in MKS 2 firmware causes several errors during compilation in stepper.cpp Could you advise the ways to resolve?

ttutuncu commented 4 years ago

I have never worked on Marlin before. But Teaching Tech on youtube has an extensive explanation on how to setup linear advance. https://www.youtube.com/watch?v=c5jjwBqARpo