Robin nano V3 is an upgraded version of Robin Nano V2.0. The upgrade changes are quite large, including upgrading the MCU to the M4 core, and adding support for USB disk.
GNU General Public License v3.0
136
stars
65
forks
source link
Robin Nano V3 reboots when start printing OR moving axis manually from TS35 V2 #105
The MKS Robin Nano V3 restarts in my Core XY printer when you send print via SD, USB, and wifi via CURA. (attached video)
It also restarts randomly by moving the axis from the screen.
I have checked that it does not happen with the original firmware, but when upgrading to marling 2.0.9 from: https://github.com/makerbase-mks/Mks-Robin-Nano-Marlin2.0-Firmware I found this problem.
I can control the printer without restarting problems from pronterface. So it is clear to me that it is a software problem
Configuration.zip
try to check the connection of the bltouch you may have reversed the pin with 2 wires and when it activates it brings the 5 volts directly to ground and the board restarts
The MKS Robin Nano V3 restarts in my Core XY printer when you send print via SD, USB, and wifi via CURA. (attached video) It also restarts randomly by moving the axis from the screen. I have checked that it does not happen with the original firmware, but when upgrading to marling 2.0.9 from: https://github.com/makerbase-mks/Mks-Robin-Nano-Marlin2.0-Firmware I found this problem. I can control the printer without restarting problems from pronterface. So it is clear to me that it is a software problem Configuration.zip
https://user-images.githubusercontent.com/24856547/165605393-73d1131e-5c03-4de2-a599-f6abaf965e4a.mp4