search

makerbase-mks / MKS-Robin-Nano-V3.X

Robin nano V3 is an upgraded version of Robin Nano V2.0. The upgrade changes are quite large, including upgrading the MCU to the M4 core, and adding support for USB disk.
GNU General Public License v3.0
134 stars 63 forks source link

How do I set MKS PWC on the klipper #132

Open sima35 opened 1 year ago

sima35 commented 1 year ago

Good, I need advice on MKS PWC and klipper. I have RB Nano v3, the clipper works great, , but I need to start MKS PWC in klipper. I did not load the information in klipper. As I understand correctly, MKS PWC is not in their settings. I would be grateful if you could give me the code for the setup. After finishing printing, my printer does not turn off automatically. And I don't know if PWC monitors the voltage. Or connection to RPI4

sima35 commented 1 year ago

when no one helped us, what could I have thought, I will give you the info here. put this in moonraker and watch out for the pin then proceed as written here in the link> https://www.etechnophiles.com/raspberry-pi-4-gpio-pinout-specifications-and-schematic/#raspberry-pi-4-gpio-pinout

this is how you can control the printer via mainsail

[power Printer] type: gpio pin: gpio14 on_when_job_queued: True off_when_shutdown: True locked_while_printing: True restart_klipper_when_powered: false initial_state: off

ColdBeer72 commented 1 year ago

Hi, @sima35... Is it working for you? I don't find a gpio14 pin in our Robin Nano V3. If you're talking about MKS PWC (not MKS UPS that is a total different think), it need a power detection and a power off connectors: one is for PW_DET pin (PA13 in Klipper) and the other is for PW_OFF pin (PB2 in Klipper). Is it really working as you told?

ColdBeer72 commented 1 year ago

Ok, friend @sima35 I could make it work without a Raspberry Pi. I explained it on this other issue, here

sima35 commented 1 year ago

Ahoj,@sima35... Funguje vám to? V našom Robin Nano V3 nenájdem pin gpio14. Ak hovoríte o MKS PWC (nie o MKS UPS, čo je úplne iný názor), potrebuje detekciu napájania a konektory vypnutia: jeden je pre pin PW_DET (PA13 v Klipper) a druhý je pre pin PW_OFF (PB2 v Klipperi). Naozaj to funguje tak, ako ste povedali?

you need to connect the pw_off cable to the rpi, I have ver.4b