search

makerbase-mks / MKS-Robin-Nano-V3.X

Robin nano V3 is an upgraded version of Robin Nano V2.0. The upgrade changes are quite large, including upgrading the MCU to the M4 core, and adding support for USB disk.
GNU General Public License v3.0
138 stars 67 forks source link

Printer stops while printing #36

Open seymon92 opened 3 years ago

seymon92 commented 3 years ago

I have problem with random stopping when printing, I use TM2208 (standaolne) stepper drivers with fan cooling and Mks-Robin-Nano-Marlin2.0-Firmware. It stops in a different layer and different spot.

Where could the problem be? Thank You

mks-viva commented 3 years ago

Hi! Can you make sure that the temperature of the heating head is constant? I guess it is caused by the fluctuation of the heating head temperature.

seymon92 commented 3 years ago

Hi, Thank You for reply. I dont think there is problem with head or bed temperature. If I do auto calibration, my printer disconnect and I cant see any information in Pronterface (but calibration continues).

I tried to print with cold head (without filament) with same result.

mks-viva commented 3 years ago

You use USB connect to PC printing?

seymon92 commented 3 years ago

Yes, I have not luck with this board, I cant connect RepRapDiscount Smart Controller with my board. I enable controller in Marlin and invert EXP connectors (previously I used SKR boards), but display only lights up, but shows no informations. So I print from computer.