SD file transfer does not work - MKS Robin Nano V3

[pagabee]

The SD file transfer does not work neither USB nor Wifi. After starting the transfer, "No firmware response detected for sd card action. Assuming success and continue" message appears and the temperature log stops. I tried out more SD cards and USB sticks.

This files were used: https://github.com/makerbase-mks/Mks-Robin-Nano-Marlin2.0-Firmware/tree/master/Firmware

Can anybody help me?

[pagabee]

The file upload works via USB, if the G-code flavor is Marlin in Slic3r.

[pagabee]

Same issue with Pronterface, file upload is ok through USB, but the Wifi transfer is nok. The TS35 screen shoes: Please check wether memory device insert!

[mks-viva]

Can you check gcode file on MKS TS35? If ok, you can try to check your network...

[pagabee]

There is either no file or there is a file with 0kb on TS35.

I think that the network is ok, because the movements, the homing, the temperature settings and feedback are ok via Wifi.

[pagabee]

Is there an other way to upload files through wifi besides Cura?

As I see the wifi modul has web view interface. Is it supported?

[Tompudex]

Is there an other way to upload files through wifi besides Cura?

As I see the wifi modul has web view interface. Is it supported?

nem. erre még várni kell. egye löre a wifi fw-t tudod itt cserélni. meg beállítani a csatlakozását.

[pagabee]

I tried out the new ESP3D 3.0 firmware on MKS WIFI. The file transfer via wifi to SD card or U drive does not work, and communication stops after that.

[pagabee]

There is no problem with Cura + MKS Wifi Plugin, but I am not using Cura slicer.