Can't adjust the offset Z parameter

makerbase-mks / MKS-Robin-Nano-V3.X

Robin nano V3 is an upgraded version of Robin Nano V2.0. The upgrade changes are quite large, including upgrading the MCU to the M4 core, and adding support for USB disk.

GNU General Public License v3.0

141 stars 69 forks source link

Can't adjust the offset Z parameter #54

Closed DoctorDeatch closed 3 years ago

DoctorDeatch commented 3 years ago

Cannot adjust induction leveling sensor the system does not allow the table to be moved to -Z The set parameter is the offset of the Z EEPROM sensor (M851 Z xx), both negative and positive are ignored how to overcome the problem?

mks-viva commented 3 years ago

https://github.com/makerbase-mks/Mks-Robin-Nano-Marlin2.0-Firmware/issues/273 So, i close this issues.