search

makerbase-mks / MKS-Robin

MKS Robin is a powerful 32-bit 3D printer control board with STM32F103ZET6 . Support Marlin2.0. Support MKS Robin TFT24/28/32... Screens. The motherboard integrates 5 AXIS interface, hot bed, 2 heating heads, 3 NTC100K, 2 MAX31855.Support MKS Robin WIFI for cloud printing.Supports firmware update by SD card…
https://es.aliexpress.com/item/32757129463.html?spm=a219c.12010612.8148356.9.5fc165f4oDUfFM
131 stars 129 forks source link

Mks Robin2 Circles printing issue. #133

Open github051 opened 5 years ago

github051 commented 5 years ago

Mks Robin2 problems:

  1. Printing via USB is not working properly. It is stopping same location even if you restart the printer.
  2. While printing circles lot of click noise is observed from motors.

I am using latest firmware of robin2.

makerbase-mks commented 5 years ago
  1. I want to confirm whether you can use the host computer to control the motherboard and realize the motor action... 2, the motor noise is large, this has a lot to do with the drive. 3, for the second question, I recommend you use MKS TMC2208 or MKS TMC2209, this driver, the mute effect is very good. MKS TMC2208：https://www.aliexpress.com/item/32888980385.html?spm=2114.12010612.8148356.1.5fba18b7vGEtua MKS TMC2209：https://www.aliexpress.com/item/33043140087.html?spm=2114.12010612.8148356.47.5fba18b7Ohqp2m
github051 commented 5 years ago

Reg Motor Noise issue: I am printing via SD card and also i am using Mks TMC2208 stepper drivers with 1/32 micro steppering. Still the noise is observed only when i am printing Circles. Normal lines are printing ok.

Same settings and same G-Code and Same TMC2208 drives with MKS Robin is printing with out any Noise.