Input and output voltage issue

makerbase-mks / MKS-Robin

MKS Robin is a powerful 32-bit 3D printer control board with STM32F103ZET6 . Support Marlin2.0. Support MKS Robin TFT24/28/32... Screens. The motherboard integrates 5 AXIS interface, hot bed, 2 heating heads, 3 NTC100K, 2 MAX31855.Support MKS Robin WIFI for cloud printing.Supports firmware update by SD card…

https://es.aliexpress.com/item/32757129463.html?spm=a219c.12010612.8148356.9.5fc165f4oDUfFM

131 stars 129 forks source link

Input and output voltage issue #149

Open Drakstein opened 5 years ago

Drakstein commented 5 years ago

I have a simple question about the voltage of the MKS ROBIN v2.4 board, it suports input 24V, but it also outputs 24V to the motors??? By the way, I will use a BL touch, anyone here already used it, any suggestions? I will use in a core XY model.

makerbase-mks commented 5 years ago

On the MKS Robin motherboard, the motor drive voltage depends on your power input voltage.

mattdog01 commented 4 years ago

@Drakstein The voltage to the stepper motors doesn't seem to really matter because your stepper drivers will only send the set/adjusted current to them. I run my board on 24volts with a corexy setup using 12volt motors (I think), but I set the current (plus a little bit) to the point where there wasn't missed steps and everything works great.