MkS-Robin Nano V1.1 not sending step pulses to E0 or E1

makerbase-mks / MKS-Robin

MKS Robin is a powerful 32-bit 3D printer control board with STM32F103ZET6 . Support Marlin2.0. Support MKS Robin TFT24/28/32... Screens. The motherboard integrates 5 AXIS interface, hot bed, 2 heating heads, 3 NTC100K, 2 MAX31855.Support MKS Robin WIFI for cloud printing.Supports firmware update by SD card…

https://es.aliexpress.com/item/32757129463.html?spm=a219c.12010612.8148356.9.5fc165f4oDUfFM

131 stars 129 forks source link

MkS-Robin Nano V1.1 not sending step pulses to E0 or E1 #179

Open gte718p opened 4 years ago

gte718p commented 4 years ago

In the middle of a print, my extruder stopped feeding. Tested individually, the stepper, stepper driver, and wiring all test good. With an Oscope, I'm not seeing pulses on the step pin of E0. E1 has never been used, but I switched to and added a fake extruder in setup E1 and not getting pulses there either. No obvious damage to the board.

I'm out of ideas to troubleshoot.

makerbase-mks commented 4 years ago

Hi! You can interchange the pin definitions of E0 and E1 pin.