makerbase-mks
commented
4 years ago Hi! Robin Nano error type
Err1: The thermal bed exceeds the maximum temperature limit, please check whether the thermal interface is shorted; Err2: The nozzle exceeds the maximum temperature limit, please check whether the thermal interface is shorted; Err3: The hot bed exceeds the minimum temperature limit, please check whether the thermal interface is disconnected; Err4: The nozzle exceeds the minimum temperature limit, please check whether the thermal interface is disconnected; Err5: The heating of the nozzle fails. If the nozzle does not reach the set temperature difference within the set time, an error will be reported; please check the configuration file settings or check whether the power supply is sufficient; Err6: The heating of the hot bed fails. If the hot bed reaches the set temperature difference within the set time, an error will be reported; please check the configuration file settings or check whether the power supply is sufficient; Err7: Thermal runaway; when the temperature reaches the target temperature, the current temperature is lower than the target temperature value within the set time and exceeds the set temperature, an error will be reported; please check whether the thermal sensitivity is normal or whether the PID value is appropriate.
I've just installed the robin nano and tft35 on a Ender 3. I am having an err1 when I try and heat the extruder, the extruder will will only stay at about 22/23 where as the bed starts shooting up and when it gets to around 100 it will show err1. The bed doesn't appear to get ho either. Any ideas?