MKS Robin is a powerful 32-bit 3D printer control board with STM32F103ZET6 . Support Marlin2.0. Support MKS Robin TFT24/28/32... Screens. The motherboard integrates 5 AXIS interface, hot bed, 2 heating heads, 3 NTC100K, 2 MAX31855.Support MKS Robin WIFI for cloud printing.Supports firmware update by SD card…
Dear MKS,
I am trying to set the autoleveling using MKS-Robin V1.0 board.
I'm not able to set the probe nor can make it to work ...
I think the enabled section of Autoleveling is for the Delta printers.
Would it be possible to
allow to set
"> ZHOME_X_POS xxx"
"> ZHOME_Y_POS xxx"
"> Z_PROBE_X_OFFSET xx"
"> Z_PROBE_Y_OFFSET xx"
Also, to know how the probe should be installed/connect to the Robin board?
Is there any pin out on the board that it should be used specially for the Z probe beside from the Z-min-endstop?
My printer is Cartesian xyz (Prusa i3 clone, the most popular one)
Dear MKS, I am trying to set the autoleveling using MKS-Robin V1.0 board. I'm not able to set the probe nor can make it to work ...
I think the enabled section of Autoleveling is for the Delta printers.
Would it be possible to
Also, to know how the probe should be installed/connect to the Robin board? Is there any pin out on the board that it should be used specially for the Z probe beside from the Z-min-endstop? My printer is Cartesian xyz (Prusa i3 clone, the most popular one)
Thanks in advance...
Robert