MKS Robin is a powerful 32-bit 3D printer control board with STM32F103ZET6 . Support Marlin2.0. Support MKS Robin TFT24/28/32... Screens. The motherboard integrates 5 AXIS interface, hot bed, 2 heating heads, 3 NTC100K, 2 MAX31855.Support MKS Robin WIFI for cloud printing.Supports firmware update by SD card…
I have a robin nano V3.1 on an ender 4. Z-Axis moves a short distance then stops, the x and y home correctly. IF I stop the motors thand home again z does not move but X-Y home correctly. I have to power down and then z-will move only one time but never homes' I have the wiring as Z1 on the motor and switch.
Configuration attached
robin2_cfg.txt
.
I have a robin nano V3.1 on an ender 4. Z-Axis moves a short distance then stops, the x and y home correctly. IF I stop the motors thand home again z does not move but X-Y home correctly. I have to power down and then z-will move only one time but never homes' I have the wiring as Z1 on the motor and switch. Configuration attached robin2_cfg.txt .