Open Actros2644 opened 6 years ago
Hello Actros2644, If you don't have a heated bed make sure you disable the heated bed or you can put a Thermistor in for the heat bed and don't set the heat. If you have a blinking red LED on the end of the board where the display plugs in then you have some form of electrical config error. At least that is what I have been able to determine when setting up my printer. Hope this helps. Matt
Hallo,
i wired all an edit the config file. Everything is working, only the stepper, they work not. I connect them to the inline stepper Driver.
Also testet with the Extruder stepper, the nozzle heat up, but it didnt work.
I use the latest Firmware
Regards