MKS Robin is a powerful 32-bit 3D printer control board with STM32F103ZET6 . Support Marlin2.0. Support MKS Robin TFT24/28/32... Screens. The motherboard integrates 5 AXIS interface, hot bed, 2 heating heads, 3 NTC100K, 2 MAX31855.Support MKS Robin WIFI for cloud printing.Supports firmware update by SD card…
Recently I own the board of you, unfortunately my former Anet Board broke.
Unfortunately, I do not manage to set up the MKS Robin Nano so that it starts in the middle of the pressure.
Alignment Works, the engines are driving in the right direction. Unfortunately that was it.
If I want to print a file, the whole schonmal not recognized by the PC, I print via SD card, they usually do not move the motors, the board does not drive in the middle but always stays on the edge. Apparently it does not recognize the right board position can you help me?
Good day,
Recently I own the board of you, unfortunately my former Anet Board broke.
Unfortunately, I do not manage to set up the MKS Robin Nano so that it starts in the middle of the pressure.
Alignment Works, the engines are driving in the right direction. Unfortunately that was it.
If I want to print a file, the whole schonmal not recognized by the PC, I print via SD card, they usually do not move the motors, the board does not drive in the middle but always stays on the edge. Apparently it does not recognize the right board position can you help me?
Many thanks in advance!