MKS Robin2 is a powerful 32-bit 3D printer control board with STM32F407ZET6 . the CPU 168MHZ. Support MKS Robin TFT35 Screens, use RobinTFT35 can preview model. The motherboard integrates 5 AXIS interface, hot bed, 2 heating heads, 3 NTC100K, 2 MAX31855.Support MKS Robin WIFI for cloud printing.Supports firmware update by SD card…
Hello,
i'm using the robin2 with tmc2208 drivers. For z-homing i want to use an inductive Probe. Right now the problem is with X and Y homed the printhead with probe is about 10mm off the printbed, the probe won't see the printbed.
Is there a section for the config file to define the homing coordinates ?
Second question, How do i enable Microstepping ? I have noticed the Jumpers under the stepper drivers but found no information what they are supposed to do.
Hello, i'm using the robin2 with tmc2208 drivers. For z-homing i want to use an inductive Probe. Right now the problem is with X and Y homed the printhead with probe is about 10mm off the printbed, the probe won't see the printbed.
Is there a section for the config file to define the homing coordinates ?
Second question, How do i enable Microstepping ? I have noticed the Jumpers under the stepper drivers but found no information what they are supposed to do.
Any Help appreciated