search

makerbase-mks / MKS-Robin2

MKS Robin2 is a powerful 32-bit 3D printer control board with STM32F407ZET6 . the CPU 168MHZ. Support MKS Robin TFT35 Screens, use RobinTFT35 can preview model. The motherboard integrates 5 AXIS interface, hot bed, 2 heating heads, 3 NTC100K, 2 MAX31855.Support MKS Robin WIFI for cloud printing.Supports firmware update by SD card…
https://www.aliexpress.com/item/33006653472.html?spm=2114.12010612.8148356.3.334a65f4LZBtt2
17 stars 12 forks source link

filament change position #13

Open JanHH2019 opened 3 years ago

JanHH2019 commented 3 years ago

I have an MKS Robin 2 with the current firmware version 1.03, if I go to filament change while printing is in progress, it moves to the point specified in the config and immediately back to the previous printing position. then when the print job is started again, it feeds matterial and starts. this always results in a blob of matterial where the nozzle then has to pass through and mess up the part.

so it is in the config

position of hotend for filament change and pause print

FILAMENT_CHANGE_X_POS 5 # X position of hotend for filament change and pause print FILAMENT_CHANGE_Y_POS 5 # Y position of hotend for filament change and pause print FILAMENT_CHANGE_Z_ADD 5 # Z addition of hotend (lift) for filament change and pause print

mks-viva commented 3 years ago

Hi! Can you provide a vodies to me?