search

makerbase-mks / MKS-SGEN_L-V2

MKS SGEN_L V2.0 is powerful 32-bit 3D printer control board. The CPU is LPC1769 120MHZ, SGEN_L V2 hardware Integrated 4KB EEPROM, 5AXIS and dual Z interface, has 2 way FANs and Dc12/24V out interface, support TMC UART and SPI mode...
https://www.aliexpress.com/item/4001283346331.html?spm=a2g0o.store_home.slider_165457030.0
GNU General Public License v3.0
71 stars 28 forks source link

Board not installing Marlin #27

Closed tatoap3 closed 3 years ago

tatoap3 commented 3 years ago

Hi!

Anyone knows if on SGEN_L V2.0, if I want to use DIR/Step mode, I connect the same mode as you show on other boards? M0 M1 and M2 jumped with the pin on the middle? And on this mode do I need to use 5 or 3,3V? I use TMC2209 drivers.

mks-viva commented 3 years ago

Hi! If you use TMC2209 DIR/Step mode

  1. You need use jumpers connect to motherboard's M0, M1; Driver IC power you can use 3.3V or 5V image

If you use TMC2209 UART mode

  1. Jumpers setting image

  2. If you use sensorless homing function, you need connect X-DIAG jumper and driver IC power connect to 3.3V image

More information, you can refer to MKS SGEN_L V2 Wiki and link is: https://github.com/makerbase-mks/MKS-SGEN_L-V2/wiki

mks-viva commented 3 years ago

Is this problem solved?

mks-viva commented 3 years ago

Hi! I will close this issues temporarily.

tatoap3 commented 3 years ago

Hi friend

Sorry to don't reply

I was trying to understand what is wrong, but I was without much time in the past weeks

The printer I was trying to install didn't work with the board. I tried with the makerbase display and with the one I had in the original kit, but the motors don't move

I seted the same vref it was in the previous kit, did all the connections right, checked over and over what could be wrong, but until now I don't know what can be...

Now the printer is on one friend's home, if you can have a clue on what's wrong and need any information please, let me know, so I ask him to take a picture or check the information...

The original kit was mounted with an arduino mega and a ramps 1.4

Thanks for all the attention so far and sorry again for the time I took to reply

Best regards

Otavio

Em dom, 13 de dez de 2020 22:47, mks-viva notifications@github.com escreveu:

Hi! I will close this issues temporarily.

— You are receiving this because you authored the thread. Reply to this email directly, view it on GitHub https://github.com/makerbase-mks/MKS-SGEN_L-V2/issues/27#issuecomment-744116923, or unsubscribe https://github.com/notifications/unsubscribe-auth/ARYEZ72Q2EV7T245GRPNYKDSUVVC5ANCNFSM4TVWWEJA .

mks-viva commented 3 years ago

I suggest you follow my instructions to test it