MKS SGEN_L V2.0 is powerful 32-bit 3D printer control board. The CPU is LPC1769 120MHZ, SGEN_L V2 hardware Integrated 4KB EEPROM, 5AXIS and dual Z interface, has 2 way FANs and Dc12/24V out interface, support TMC UART and SPI mode...
Hey,
A while ago I bought the MKS Sgen L V2 motherboard and used it with the tmc2100 stepper drivers. However, after I blew up the drivers while trying to put them in spreadcycle mode..
Because of this, I bought the MKS tmc2209 drivers and I wonder if there is any video/document available on how to use these drivers and enable the stallguard (sensorless homing) in this combo. (MKS Sgen L V2 and MKS tmc2209)
I hope to hear from you.
Thanks
Hey, A while ago I bought the MKS Sgen L V2 motherboard and used it with the tmc2100 stepper drivers. However, after I blew up the drivers while trying to put them in spreadcycle mode.. Because of this, I bought the MKS tmc2209 drivers and I wonder if there is any video/document available on how to use these drivers and enable the stallguard (sensorless homing) in this combo. (MKS Sgen L V2 and MKS tmc2209) I hope to hear from you. Thanks