MKS SKIPR is an all-in-one board launched by Makerbase for running Klipper. It integrates the RK3328 SOC running the Klipper host and the STM32F407VET6 MCU responsible for executing specific machine actions. It meets the use of most 3D printers.
Hello,
I having problem to make work the tmc2208 driver without uart mode. I set the jumpers in normal mode on the board and in printer.cfg i disabled uart mode. When I try to homing keep complaining about Uart pin have to be set. When I take out the "#" then saying cannot read uart .(off course because I don't have uart on tmc2208.
Hello, I having problem to make work the tmc2208 driver without uart mode. I set the jumpers in normal mode on the board and in printer.cfg i disabled uart mode. When I try to homing keep complaining about Uart pin have to be set. When I take out the "#" then saying cannot read uart .(off course because I don't have uart on tmc2208.