search

makerbase-mks / MKS-SKIPR

MKS SKIPR is an all-in-one board launched by Makerbase for running Klipper. It integrates the RK3328 SOC running the Klipper host and the STM32F407VET6 MCU responsible for executing specific machine actions. It meets the use of most 3D printers.
GNU General Public License v3.0
88 stars 14 forks source link

cant make work wifi doggle #38

Open chriskleov opened 1 year ago

chriskleov commented 1 year ago

i use RTL8188EUS. Its power on normally i can find it at usb list but at arnbian config i cant find network => wifi. i edit wpa file at boot not succed

Printhing3d commented 1 year ago

Check wpa-suplicant.conf file. You missed something

botio commented 1 year ago

the only way to use the wifi with the newest OS image(20230301) mks provided is using the cable first and ssh login, type sudo armbian-confg. then set up the wifi connection, but after reboot... not sure if it's still working. MKS did very bad job for updating OS and provide okay doc to use their product... smh

chriskleov commented 1 year ago

I will try...

Χ.Κ

From: Botio Studio @.> Sent: Thursday, March 30, 2023 11:26:21 AM To: makerbase-mks/MKS-SKIPR @.> Cc: chriskleov @.>; Author @.> Subject: Re: [makerbase-mks/MKS-SKIPR] cant make work wifi doggle (Issue #38)

the only way to use the wifi with the newest OS image(20230301) mks provided is using the cable first and ssh login, type sudo armbian-confg. then set up the wifi connection, but after reboot... not sure if it's still working.

— Reply to this email directly, view it on GitHubhttps://github.com/makerbase-mks/MKS-SKIPR/issues/38#issuecomment-1489899562, or unsubscribehttps://github.com/notifications/unsubscribe-auth/ARF5YKFHKT3JWJMXZDEJDNDW6U7S3ANCNFSM6AAAAAAVZS44TI. You are receiving this because you authored the thread.Message ID: @.***>