Filament Runout Sensor is not working on MKS Tinybee and H43 Display

[Moditek]

I am using "MKS Tinybee marlin" firmware. I could make everything work except "FILAMENT RUNOUT SENSOR" I pluged the cable to "MT det" Pin. I changed parameter that showed me on "MKS Tiny Bee" user manual pdf for configuration.h and adv.h

also I changed pins>pins_MKS_TINYBEE.h.

//

define X_STOP_PIN 33

define Y_STOP_PIN 32

define Z_STOP_PIN 22

define FIL_RUNOUT_PIN 35

Please Help

[MKS-hosiey]

Did you enable the run_out sensor in the configuration file?

[Moditek]

Yes I did. But When I fill it, All tempature are going fall down. When I try to start printing, Error Message appear. “ Min Temp Foult” something like that.

Windows için Postahttps://go.microsoft.com/fwlink/?LinkId=550986 ile gönderildi

Kimden: @.> Gönderilme: 29 Aralık 2022 Perşembe 05:29 Kime: @.> Bilgi: @.>; @.> Konu: Re: [makerbase-mks/MKS-TinyBee] Filament Runout Sensor is not working on MKS Tinybee and H43 Display (Issue #76)

Did you enable the run_out sensor in the configuration file?

— Reply to this email directly, view it on GitHubhttps://github.com/makerbase-mks/MKS-TinyBee/issues/76#issuecomment-1367032702, or unsubscribehttps://github.com/notifications/unsubscribe-auth/A4VZML2B45YA5YUPASZZAITWPTZSFANCNFSM6AAAAAAS2YZMRQ. You are receiving this because you authored the thread.Message ID: @.***>

[Marcel67921]

do you have the wires of the runout sensor connector connected to the board well? I had to switch them according to the plate.

• red wire +
• black wire GND
• white wire S

[sherwinrastegar]

Hello, I have the same problem, and when I compile, it says that the board does not support this display. can you help me ?

[Marcel67921]

Hello,

check the wiring . + to +, Gnd to Gnd and Signal to Signal. Runout sensors differ in the connection of the connector.

Best regards.

---------- Původní e-mail ---------- Od: sherwinrastegar @.> Komu: makerbase-mks/MKS-TinyBee @.> Kopie: Marcel67921 @.>, Comment @. github.com> Datum: 11. 9. 2023 20:58:23 Předmět: Re: [makerbase-mks/MKS-TinyBee] Filament Runout Sensor is not working on MKS Tinybee and H43 Display (Issue #76) "

Hello, I have the same problem, and when I compile, it says that the board does not support this display. can you help me ?

— Reply to this email directly, view it on GitHub (https://github.com/makerbase-mks/MKS-TinyBee/issues/76#issuecomment-1714419828) , or unsubscribe (https://github.com/notifications/unsubscribe-auth/A7C3WAW3BHYXYCI7TSQTWO3XZ5NMXANCNFSM6AAAAAAS2YZMRQ) . You are receiving this because you commented. Message ID: <makerbase-mks/MKS @.***> "

[Marcel67921]

[Marcel67921]

S GND +5V

[Marcel67921]

[Marcel67921]