Closed ahmedhassan3298 closed 1 year ago
https://github.com/makerbase-mks/MKS-TinyBee/issues/36 Check this, maybe it helps you. Try using only 2 pins for the endstops
Thanks for your help I Try 2 pins (S,G) for the end stop The end stop dont stop the motor
Is it tied NC (normally closed) the switch? If the switch has 3 pins u should tie the two from each side and leave the middle pin unconnected. Also make sure it is in the right axis slot, x, y, z
Hi all, my MKS tinybee board give error in temperature when i connect end stop for y-axis