Closed dvseliteus closed 6 years ago
did you try to reverse the connector ..ie cut off the notch and put it in opposite direction mks 1.4 boards have that problem
I had the wrong ramps version in the firmware. Thanks for the help!
@dvseliteus i have a mks gen 1.4 and i tried the ramps marlin firmware but sometimes when i give commands like move +x axis 10mm 5 times it moves only 4 times do you know anything about that? is mks boards unlreliable?
@amrithmmh what board do you have specified in Marlin? Should be #define MOTHERBOARD BOARD_MKS_13
@3daddict it turns out that one of my motor was dying and now gone for good the mks board is ok and no i gave #define MOTHERBOARD BOARD_RAMPS_14_EFB and now it works fine though
No matter what I try I cannot get my Makerbase MKS MINI12864 v1.0 work with the latest version of Marlin 1.1.x What is the correct LCD configuration?