Closed GoogleCodeExporter closed 9 years ago
did you try holding control or turning "snap to grid" option?
Original comment by bancika@gmail.com
on 1 Jul 2011 at 1:11
I just tried it. If I temporarily turn off grid snapping I can carefully
position the wire or component end on the tube socket pin.
Then everything will move together in sticky mode. That is a fair
work-around as alternative to snap-to-pin.
Since snap-to-grid is the main mechanism in diy-layout-creator for keeping
things aligned, I tend to keep it checked.
A hot-key to toggle the snap-to-grid might be nice for these kind of touch
ups.
Thanks!
Original comment by sta...@gmail.com
on 1 Jul 2011 at 4:34
try shift or ctrl
Original comment by bancika@gmail.com
on 1 Jul 2011 at 4:39
Doesn't seem that either shift or ctrl will affect the grid snapping.
Ctrl will disable the sticky-points though.
Original comment by sta...@gmail.com
on 2 Jul 2011 at 1:56
added ctrl+shift for toggling the snap to grid option
Original comment by bancika@gmail.com
on 8 Feb 2012 at 4:57
Original issue reported on code.google.com by
sta...@gmail.com
on 1 Jul 2011 at 12:59