Support for SKR-mini-e3

maocypher / Octoprint-Smart-Filament-Sensor

OctoPrint plugin that lets integrate Smart Filament Sensors like BigTreeTechs SmartFilamentSensor directly to RaspberryPi GPIO pins.

GNU General Public License v3.0

13 stars 20 forks source link

Open jacix opened 3 years ago

jacix commented 3 years ago

Hello,

Does this plugin support connecting the sensor to the dedicated port on the skr-mini-e3 board? If not, could that be added?

Thanks!

maocypher commented 3 years ago

Currently this is not supported. As you configure in the firmware to send M600. Did you simply try configuring M600 as pausing command in OctoPrint?

This week I managed setting up my SKR board, but to figure out what is happening, it would take some time, because I am quite busy currently