Open GoogleCodeExporter opened 9 years ago
4) The motor may not be spinning fast enough to satisfy our ~30Hz refresh rate,
but mounting the disc to the motor shaft seems infeasible. We need to test our
RPM once the base is completed.
1) (EDIT) May need to grind off ridges on outermost parts (furthest from axis
of rotation) on disc to eliminate air resistance. This may help reduce wobbling
and increase RPM.
5) Need to discuss calibration monitor / RPM meter (probably a photoeye
connected to an arduino or something) (also requires base to be completed).
Original comment by marcu...@miamioh.edu
on 9 Feb 2013 at 10:51
6) We may need to look into power smoothing once we have to start providing
power to the raspberry pi / etc. I don't want to blow out any circuits and I
think that our brushing system will give a lot of interruptions, so we may have
to find some 24v capacitors to smooth out or power supply when it's interrupted.
Original comment by marcu...@miamioh.edu
on 9 Feb 2013 at 10:56
Original issue reported on code.google.com by
jamietmo...@gmail.com
on 9 Feb 2013 at 10:43