Open bombsquad85 opened 2 weeks ago
Hello, what's hardware version on the BDsensorM, there is a different of the SDA and SCL pin number between the V1.0 and V1.1, which you can see from the text string on the pcb board.
Hello, what's hardware version on the BDsensorM, there is a different of the SDA and SCL pin number between the V1.0 and V1.1, which you can see from the text string on the pcb board.
its a v1.1
Hello, what's hardware version on the BDsensorM, there is a different of the SDA and SCL pin number between the V1.0 and V1.1, which you can see from the text string on the pcb board.
ok, i got it to work with the BL touch connectors. any reason why it didnt work with EXP1?
the pin name should be configured as following for the BDsensorM v1.1 connecting to Octopus 1.1 with EXP1
sda_pin: PE10
scl_pin: PE9
the pin name should be configured as following for the BDsensorM v1.1 connecting to Octopus 1.1 with EXP1
sda_pin: PE10 scl_pin: PE9
Thank you for this response. I have since gotten it to work using the BL touch connectors and it is working wonderfully.
Need a little help here.
i have flashed the firmware several times and finally got it to install w/o throwing a warning about the firmware being dirty and needing to be updated.
now that that is out of the way i am getting issues when i check the connection and i get Bed Distance Sensor data error2:10.24.
i have the type M sensor and it is installed the same way as pictured in the github example.
my mainboard is an Octopus 1.1 the BD config section is as follows: [BDsensor]
Don't use aliases for the board pins
sda_pin: PE15 scl_pin: PE14 delay: 20 # you can set it 10 if the BDsensor version is >=1.2 z_offset:0 # within -0.6 to 0.6mm x_offset: 0 y_offset: 20 no_stop_probe: # fast probe that the toolhead will not stop at the probe point,disable it by commenting out. position_endstop: 1.2 #the triggered position, recommend value is 1~2.8 collision_homing:0 # set it 1 to enable homing with nozzle collision sensing. collision_calibrate:0 # set it 1 to enable auto calibrate BDsensor with nozzle collision sensing.
QGL_Tilt_Probe:0 #set 1 to enable probe up and down when do quad_gantry_level
the cable is securely connected to the exp1 module. [board_pins] aliases:
EXP1 header
i thought everything was done correctly https://github.com/markniu/Bed_Distance_sensor/wiki/BDsensor-M
any idea what i missed? i literally just spent over 2 hours trying to figure this out.
TIA