search

markniu / PandaPi

3d printer firmware run on raspberry pi directly
215 stars 30 forks source link

Closed Loop Motor Support. #14

Open designerwebhosting opened 4 years ago

designerwebhosting commented 4 years ago

Does the Pandapi Hat support Closed Loop Motors? Or is it just updating the Marlin config to use them? Thank you.

markniu commented 4 years ago

Hi, just like other 3D printer control board, only support step motor driver TMC2209/2208/ A4988 ..., not support closed loop motor. it based on the marlin,so the configuration is the same.

Moorviper commented 4 years ago

As far i know do you use closed loop driver just as A4988. You don't have to change anything in firmware. 1/16 micro stepping and you are good to go