search

markwal / OctoPrint-GPX

An OctoPrint plug-in to use GPX as the protocol layer underneath rather than replacing g-code to talk to s3g/x3g machines, for example, a FlashForge.
GNU Affero General Public License v3.0
104 stars 25 forks source link

FFCP #65

Closed icancwhatusay closed 4 years ago

icancwhatusay commented 5 years ago

Printer loses connection about 1m 45s after print starts. The amount of time it takes before it loses connection is not consistent. Sometimes I lose it within 10s of the print starting but it's always after the print begins printing and not during heat up.

I'll have connection during HBP heat up and Extruder heat up but once the print starts, I have approximately 30 seconds before it losses connection

The printer stays heated after connection is lost.

Error: State: Offline (Error: IOError: 'Serial communication error' @ comm.py:_do_send_without_checksum:3189)

icancwhatusay commented 4 years ago

I no longer have an FFCP to test with and it's been over a year without reply. Octorprint was working fine with my FFCP before I sold it.