temp1 is listed for all 20 sensors under label and sensor
Steps to reproduce the behaviour
install on any yoga c630 arm64 laptop (and possibly anybox with thermal drivers connected to hwmon via THERMAL_HWMON kernel config option)
MATE general version
1.24
Package version
1.24.0+1
Linux Distribution
ubuntu 20.04
So mate applets currently displays temp1 for label and sensor. I know when THERMAL_HWMON is used/needed it put all temps in the /sys/class/hwmon/hwmon*/temp1_input, I tried looking at your code to see if it was using the folder name etc, but it was above my head.
sensors -A
shows correct names IE # I used the -A to remove adapters to make it more clear;
cpu6_thermal-virtual-0
temp1: +39.7°C (crit = +100.0°C)
I could see sum of the code was borrowed from the sensors app, but I couldnt figure out which code showed which or where to replace. If a command line option or a build option to switch the naming could happen thatd be great. If not if anyone can help me switch the code to show the correct name, Id be greatly appreciative! The only sensor with a diff name is in0 for the battery and its placement in the list changes sporadically making it impossible to figure out how the list is ordered. Thank you
Expected behaviour
different names for each sensor
Actual behaviour
temp1 is listed for all 20 sensors under label and sensor
Steps to reproduce the behaviour
install on any yoga c630 arm64 laptop (and possibly anybox with thermal drivers connected to hwmon via THERMAL_HWMON kernel config option)
MATE general version
1.24
Package version
1.24.0+1
Linux Distribution
ubuntu 20.04
So mate applets currently displays temp1 for label and sensor. I know when THERMAL_HWMON is used/needed it put all temps in the /sys/class/hwmon/hwmon*/temp1_input, I tried looking at your code to see if it was using the folder name etc, but it was above my head. sensors -A
shows correct names IE # I used the -A to remove adapters to make it more clear; cpu6_thermal-virtual-0 temp1: +39.7°C (crit = +100.0°C)
I could see sum of the code was borrowed from the sensors app, but I couldnt figure out which code showed which or where to replace. If a command line option or a build option to switch the naming could happen thatd be great. If not if anyone can help me switch the code to show the correct name, Id be greatly appreciative! The only sensor with a diff name is in0 for the battery and its placement in the list changes sporadically making it impossible to figure out how the list is ordered. Thank you