I have had a STC-1000 for a month or so now and was just trying to flash it this morning. When I removed the case I noticed the the 5 nice neat solder locations for the header pins were absent. There are 5 pins labeled but spread out across the front of the board. (NTC1, NTC2, VCC, RST, GND) Can you tell me what the pin-out is so I can try and flash this one? Also if it helps the info on what looks like the embedded PIC is "HOLTEK HT66F40 B433K0667G3" Any help or insight. Would be awesome. I am in need on a second controller so I just ordered 2 additional units from separate amazon sellers. I will see what version of the hardware I get when they arrive.
I have had a STC-1000 for a month or so now and was just trying to flash it this morning. When I removed the case I noticed the the 5 nice neat solder locations for the header pins were absent. There are 5 pins labeled but spread out across the front of the board. (NTC1, NTC2, VCC, RST, GND) Can you tell me what the pin-out is so I can try and flash this one? Also if it helps the info on what looks like the embedded PIC is "HOLTEK HT66F40 B433K0667G3" Any help or insight. Would be awesome. I am in need on a second controller so I just ordered 2 additional units from separate amazon sellers. I will see what version of the hardware I get when they arrive.