In step 11 i didn't checked the test on the backside and rely on the "newer version". So i desided to put the 5V booster upside down. Which i now know was wrong. Proposal: May be you can link on our website to the much better git up assembly instructionV3.
But on both configs (booster upside down and right) my Thermocam won't wake up if i switch on.
If i reconnect the VUSB and VIN pads on the backside my Thermocam wake up and works perfectly. I also could managed to flash to the newest firmware.
When i disconnect the pads again my cam won't wake up. Do you think the booster is damaged? Do you have any idea where to look for some errors?
Hey Max, hey git hub community,
many thx for the really nice Thermocam!
What i did so far...
But on both configs (booster upside down and right) my Thermocam won't wake up if i switch on.
If i reconnect the VUSB and VIN pads on the backside my Thermocam wake up and works perfectly. I also could managed to flash to the newest firmware. When i disconnect the pads again my cam won't wake up. Do you think the booster is damaged? Do you have any idea where to look for some errors?
Many thx from near Munich Andreas