search

meatpiHQ / wican-fw

GNU General Public License v3.0
309 stars 65 forks source link

boot loop with v3.27 (and also v3.28) #188

Closed rcmcronny closed 1 month ago

rcmcronny commented 2 months ago

I did an upgrade to 3.27 some days ago and the adapter goes into a bootloop, it did get a short look on seriell and it showed a parsing error , did not have it anymore in detail. So, today the 3.28 came out and i disassembled the adapter and flashed over usb with full factory reset. I connected, configured ap+station with new passwortd and the wifi data. Save -> reboot and all fine. Then i configured the autpid protokoll -> save and boot loop, as the seriel was not stable cause of the quick reboots, i did not see any detail.

So i factory reset it again, and configured ap+station , new password, uploaded the vehicle json and set it to generic ca and enabled, but leave the protocol on slcan. This is stable now. I just do not want to change it and have to disassemble it again ;) I wanted to get more data with car scanner,l but no time till today, so only tinkering from time to time shortly.

meatpiHQ commented 2 months ago

@rcmcronny sorry about that, this is fixed in v3.30

https://github.com/meatpiHQ/wican-fw/releases/tag/v3.30

rcmcronny commented 2 months ago

Hi, all good,

i reported it, to hopefully get a fixed version, and you nailed it :)

Thanks Ronny

panlinux commented 1 month ago

I suppose this issue can be closed? I had the same issue, and 3.30 fixed it for me.

rcmcronny commented 1 month ago

Yes, i wanted to check it, as you did it, we can close it :) Thanks.