Closed nicocoetzee closed 8 months ago
I think I found the problem. I installed the router firmware vs. coordinator. But now I cannot update the correct firmware. I get the below error. Any advice would be greatly appreciated.
`s6-rc: info: service s6rc-oneshot-runner: starting s6-rc: info: service s6rc-oneshot-runner successfully started s6-rc: info: service fix-attrs: starting s6-rc: info: service fix-attrs successfully started s6-rc: info: service legacy-cont-init: starting s6-rc: info: service legacy-cont-init successfully started s6-rc: info: service banner: starting
s6-rc: info: service banner successfully started s6-rc: info: service cc2652-flasher: starting [10:12:20] INFO: Starting CC2652P flasher with Sonoff /dev/ttyUSB2 Setting filename to /root/firmware.hex sonoff Opening port /dev/ttyUSB2, baud 500000 Reading data from /root/firmware.hex Your firmware looks like an Intel Hex file Connecting to target... ERROR: Timeout waiting for ACK/NACK after 'Synch (0x55 0x55)' [10:12:22] INFO: cc2652-flasher-up script exited with code 1 s6-rc: warning: unable to start service cc2652-flasher: command exited 1 s6-rc: info: service banner: stopping /run/s6/basedir/scripts/rc.init: warning: s6-rc failed to properly bring all the services up! Check your logs (in /run/uncaught-logs/current if you have in-container logging) for more information. /run/s6/basedir/scripts/rc.init: fatal: stopping the container. s6-rc: info: service banner successfully stopped s6-rc: info: service legacy-cont-init: stopping s6-rc: info: service legacy-cont-init successfully stopped s6-rc: info: service fix-attrs: stopping s6-rc: info: service fix-attrs successfully stopped s6-rc: info: service s6rc-oneshot-runner: stopping s6-rc: info: service s6rc-oneshot-runner successfully stopped`
Hi, sorry i think you will need to put manually in bootlooader mode. I'm not sure,because i dont have this device on hands.
I am reaching out for some assistance with my SONOFF Zigbee 3.0 USB Dongle Plus ZBDongle-P. I followed the setup instructions (ZigStar TI CC2652 FW Flasher) similar to your guide and the flasher log indicates everything went smoothly. However, I'm experiencing an issue with Zigbee2MQTT. When I try to start it, I'm getting an error as shown in this link: https://t.ly/Rxw3_. This has resulted in my Zigbee network being currently non-functional. I would really appreciate any guidance or support you could offer to resolve this issue. Thank you in advance for your time and help!