Open geoffreygarrett opened 4 months ago
I'm having similar issues trying to use the meshtastic client and configuring mqtt settings.
It'll routinely just not update the root, or ... most other settings on change. Try it a few times and it'll come good, sometimes.
I have a feeling that there's possibly some more we could be doing in the CLI to send these commands better or to better verify they've gone through -- leaving a note here to remind myself but also in case anyone else feels up to it, but probably comparing with what the Android and iOS apps (especially Android since it supports TCP) are doing would be the place to start on this. It's also possible that adding the --wait-to-disconnect
argument will improve the behavior in some of these regards, but that's all a little unclear to me at present.
Versions and Firmware
--set
has no effect with--host
--configure
doesn't changeignoreMqtt
...e0cea5f8.yaml
It doesn't matter if I have it commented out or not, I simply cannot configure a from scratch, without the UI due to the
ignoreMqtt
not being affected by any CLI commands. I have tried both snake_case and camelCase, but I can see internally it's converting regardless.This is a bit of an issue for me, I need a simple streamline way of configuring devices from scratch, and then updating via CI/CD at a later time remotely. I was hoping
--configure
would be effective but it seems not.